This year, the extrusion machine accessories industry may have a relatively low position in recent years.

With the increasing production of extrusion machine parts in China, the industrial development is very rapid, which is mainly benefited from the unique market advantage of our country. Aluminum alloy die casting is very widely used, especially in the automobile industry, the demand of aluminum alloy die casting is very large. China's automobile industry has been developing rapidly in recent years, and the demand for aluminum alloy die castings has increased rapidly, which greatly promoted the development of China's aluminum alloy die castings industry. Especially in the light of the trend of vehicle lightweight, the global aluminum alloy die castings Market has seen huge demand, and the demand of China's auto industry is much less. At the same time, due to the optimization of auto industry upgrading, is gradually used Aluminum Alloy castings instead of castings, so as to continuously stimulation on Aluminum Alloy casting demand growth. The automotive industry is still developing and expanding in China. Under the above trend, the advantage of China's aluminum die castings industry is strong.

As for the recent market going suddenly, experts remind us that we should pay close attention to the final destination of the machine. Is it to the investors, the middle dealers or the end users? People should have a good attitude to look at the normal speed of development, in the future, the extrusion machine parts industry should not appear the situation of excessive growth. There is still no change in financial policy and loan conditions, and fiscal policy continues to maintain a steady state. Even if the state is to "guarantee" the industry, under the unified political order, it is also very difficult to receive special care. It is one of the big problems that most enterprises in the industry are facing. At the same time, the profit continues to reduce, the bumper harvest is not rich, under the role of the above multiple factors, more obvious. The industry concerned outstanding debt problem to the managers, it is suggested that enterprises boycott to alleviate the financial pressure on credit.

Because the traditional extruder accessories have two different types of full hydraulic and elbow type, there are no differences in conventional die casting, but they are different when used for extrusion die casting. The extrusion die casting and common die casting are respectively based on the following aspects: after casting, after extrusion, squeeze casting increases a main cylinder power to move forward, and the normal die casting is just natural cooling, and there is no feeding step. The extrusion die casting process can only be used by the traditional die casting machine, only the clamping force is used, and only the clamping force is a driving force forward. The size of the clamping force determines the size of the extrusion force. Therefore, the full hydraulic pressure type traditional extrusion press is the clamping force of the extruder, and it can also be used as the extrusion and filling force. However, the forward extrusion force of the elbow type die casting machine is equal to the clamping force of the clamping cylinder multiplied by the lever ratio of the clamping mechanism, but it can not exceed the compression strength that the clamping mechanism can bear.

This year, the extrusion machine accessories industry may have a relatively low position in recent years. Especially since the first half of last year have been too much reason, the first half of this year a few months before the situation is not optimistic. In addition, some agents reflected that the payment situation was better than last year, the instalment reduced and the brand concentration increased significantly. The situation in this period may affect the market pattern of the whole year. It is estimated that the growth rate of fixed assets investment in China is now over 26%. Because of the high international monopoly of its industry, it is difficult to fall back once it rises, which is not easy to finish in the period of 5 to 10 years. Strict control of house prices has become the focus of a new round of regulation. In recent years, the situation of overheating of real estate has reached the point that must be strictly controlled. The impact of real estate construction on the extrusion machine parts industry may not be direct, but it can not be ignored. Restraining the price of production data and the rising price of real estate have become the focus of the recent government's economic work.